Introduce some welding automatic operator daily maintenance rules
Date：2021-10-20 Views：461
The moving parts of the welding automatic operator, guide rail and roller should be coated with grease, and the closed transmission parts should be filled with lubricating oil to keep the parts moving flexibly; The focus is on the maintenance of the flat core wheel and eccentric wheel components to ensure that they are tight and to ensure that the transverse arm movement is straight. Often check and clean the moving parts of the guide rail, slide frame, lead screw and nut to prevent dust accumulation, scattering flux and other debris, affecting the flexible movement of the moving parts.
It is not allowed to collide or wear the joint surface of each sliding guide rail. Regularly inspect the wear and tear of key moving components such as screws and racks, and promptly repair or replace any problems found, while lifting the nuts. The chain in the welding automation operation machine is a vulnerable component, which should be removed and inspected at least once a year for timely handling.
Welding automation often checks the flexibility and reliability of each travel switch, as well as whether the mechanical protection block is loose or damaged. The fuse of the circuit should be used according to regulations and the specifications should not be changed arbitrarily. If the fuse is burnt out, the cause should be identified, and the fault should be eliminated before replacement.
Regularly check the circuit connectors to ensure they are securely connected and reliably plugged in. Once every three months, use compressed air to sweep the dust inside the workstation controller and manual operator, keeping the relays, knobs, switches, etc. clean and in good contact to avoid misoperation.
The moving parts of the welding automatic operator, guide rail and roller should be coated with grease, and the closed transmission parts should be filled with lubricating oil to keep the parts moving flexibly; The focus is on the maintenance of the flat core wheel and eccentric wheel components to ensure that they are tight and to ensure that the transverse arm movement is straight. Often check and clean the moving parts of the guide rail, slide frame, lead screw and nut to prevent dust accumulation, scattering flux and other debris, affecting the flexible movement of the moving parts.
It is not allowed to collide or wear the joint surface of each sliding guide rail. Regularly inspect the wear and tear of key moving components such as screws and racks, and promptly repair or replace any problems found, while lifting the nuts. The chain in the welding automation operation machine is a vulnerable component, which should be removed and inspected at least once a year for timely handling.
Welding automation often checks the flexibility and reliability of each travel switch, as well as whether the mechanical protection block is loose or damaged. The fuse of the circuit should be used according to regulations and the specifications should not be changed arbitrarily. If the fuse is burnt out, the cause should be identified, and the fault should be eliminated before replacement.
Regularly check the circuit connectors to ensure they are securely connected and reliably plugged in. Once every three months, use compressed air to sweep the dust inside the workstation controller and manual operator, keeping the relays, knobs, switches, etc. clean and in good contact to avoid misoperation.
